Related provisions for BIPRU 9.11.1
1 - 18 of 18 items.
Where there is a securitisation of revolving exposures subject to an early amortisation provision, the originator must calculate an additional risk weighted exposure amount in accordance with this section in respect of the risk that the levels of credit risk to which it is exposed may increase following the operation of the early amortisation provision. Accordingly this section sets out how an originator must calculate a risk weighted exposure amount when it sells revolving exposures
In the case of a securitisation meeting the conditions in this paragraph, a firm may apply to the FSA for a waiver that would allow a treatment which approximates closely to that prescribed in BIPRU 9.13.13 R to BIPRU 9.13.17 R for determining the conversion figure indicated. If a firm wants such a waiver, it should satisfy the FSA that:(1) the securitisation is subject to an early amortisation provision of retail exposures;(2) those retail exposures are uncommitted and unconditionally
For an originator, a sponsor, or for other firms which can calculate KIRB, the risk weighted exposure amounts calculated in respect of its positions in a securitisation may be limited to that which would produce an amount in respect of its credit risk capital requirement equal to the sum of 8% of the risk weighted exposure amount which would be produced if the securitised assets had not been securitised and were on the balance sheet of the firm plus the expected loss amounts of
(1) If:(a) a firm'sIRB permission allows it to use this treatment; and(b) the conditions in (2)(16) are satisfied,a firm may attribute to an unrated position in an asset backed commercial paper programme a derived rating as laid down in (3).(2) Positions in the commercial paper issued from the programme must be rated positions.(3) Under the ABCP internal assessment approach, the unrated position must be assigned by the firm to one of the rating grades described in (5). The position
(1) Subject to any permission of the type described in BIPRU 9.12.28 G, the risk weight to be applied to the exposure amount must be:12.5 (S[L+T] - S[L]) / T(2) The remaining provisions of this paragraph define the terms used in the formulae in (1) and (3).(3) 2(4) (5) (6) (7) (8) (9) (10) (11) (12) (13) (14) (15) In these expressions, Beta [x; a, b]refers to the cumulative beta distribution with parameters a and b evaluated at x.(16) T (the thickness of the tranche in which the
The originator of a traditional securitisation may exclude securitised exposures from the calculation of risk weighted exposure amounts and expected loss amounts if either of the following conditions is fulfilled:(1) 2significant credit risk associated with the securitised exposures is considered to have been transferred to third parties; or(2) 2the originator applies a 1250% risk weight to all securitisation positions it holds in the securitisation or deducts these securitisation
2Significant credit risk will be considered to be transferred for an originator in the following cases:(1) 2the risk weighted exposure amounts of the mezzanine securitisation positions held by the originator in the securitisation do not exceed 50% of the risk weighted exposure amounts of all mezzanine securitisation positions existing in this securitisation;(2) 2where there are no mezzanine securitisation positions in a given securitisation and the originator can demonstrate that
When the conditions in this paragraph have been met, and in order to determine its exposure value, a conversion figure of 50% may be applied to the nominal amount of a liquidity facility. The risk weight to be applied is the highest risk weight that would be applied to any of the securitised exposures under the standardised approach by a firm holding the exposures. Those conditions are as follows:11(1) the liquidity facility documentation must clearly identify and limit the circumstances
In the case of funded credit protection, the risk weighted exposure amount of the securitisation position must be calculated by multiplying the funded protection-adjusted exposure amount of the position (E*, as calculated under BIPRU 5.4.28 R (3), taking the amount of the securitisation position to be E) by the effective risk weight.[Note:BCD Annex IX Part 4 point 64]
To calculate the risk weighted exposure amount of a securitisation position, the relevant risk weight must be assigned to the exposure value of the position in accordance with BIPRU 9.9 - BIPRU 9.14 based on the credit quality of the position.[Note:BCD Article 96(1) (part) and Annex IX1, Part 4 point 1]
Subject to the provisions of GENPRU that deal with the deduction of securitisation positions at stage M in the relevant capital resources table, the risk weighted exposure amount must be included in the firm's total of risk weighted exposure amounts for the purposes of the calculation of its credit risk capital requirement.[Note:BCD Article 96(4)]
(1) An originator of a synthetic securitisation may calculate risk weighted exposure amounts1, and, as relevant, expected loss amounts, for the securitised exposures in accordance with BIPRU 9.5.3 R and BIPRU 9.5.4 R, if either of the following conditions is fulfilled:1(a) 1significant credit risk is considered to have been transferred to third parties, either through funded or unfunded credit protection; or(b) 1the originator applies a 1250% risk weight to all securitisation
(1) In calculating risk weighted exposure amounts for the securitised exposures, where the conditions in BIPRU 9.5.1 R are met, the originator of a synthetic securitisation must, subject to the treatment of maturity mismatches set out in BIPRU 9.5.6 R-BIPRU 9.5.8 R, use the relevant calculation methodologies set out in BIPRU 9.9-BIPRU 9.14and not those set out in BIPRU 3 (Standardised credit risk) or BIPRU 4 (IRB approach).(2) For firms calculating risk weighted exposure amounts
Subject to the treatment of maturity mismatches set out in BIPRU 9.5.6 R-BIPRU 9.5.8 R, the originator must calculate risk weighted exposure amounts in respect of all tranches in the securitisation in accordance with the provisions of BIPRU 9.9-BIPRU 9.14. For example, where a tranche is transferred by means of unfunded credit protection to a third party, the risk weight of that third party must be applied to the tranche in the calculation of the originatorsrisk weighted exposure
For the purposes of calculating risk weighted exposure amounts in accordance with BIPRU 9.5.3 R, any maturity mismatch between the credit protection by which the tranching is achieved and the securitised exposures must be taken into consideration in accordance with BIPRU 9.5.7 R-BIPRU 9.5.8 R.[Note:BCD Annex IX Part 2 point 5]
(1) An originator must ignore any maturity mismatch in calculating risk weighted exposure amounts for tranches appearing pursuant to BIPRU 9.9-BIPRU 9.14 with a risk weight of 1250%. For all other tranches the maturity mismatch treatment prescribed in BIPRU 5.8 (Maturity mismatches) must be applied in accordance with the following formula:RW* is [RW(SP) x (t-t*)/(T-t*)] + [RW(Ass) x (T-t)/(T-t*)](2) The following apply for the purposes of the formula in (1):(a) RW* is risk weighted
A firm calculating risk weighted exposure amounts in accordance with BIPRU 9 or capital resource requirements according to BIPRU 7.2.48A R to BIPRU 7.2.48K R4 must disclose the following information, where relevant separately for its trading book and non-trading book:4(1) a description of the firm's objectives in relation to securitisation activity;(1A) the nature of other risks, including liquidity risk inherent in securitised assets;4(1B) the type of risks in terms of seniority
1Significant credit risk will be considered to have been transferred for originators in the following cases:(1) the risk weighted exposure amounts of the mezzanine securitisation positions held by the originator in the securitisation do not exceed 50% of the risk weighted exposure amounts of all mezzanine securitisation positions existing in this securitisation;(2) where there are no mezzanine securitisation positions in a given securitisation and the originator can demonstrate
(1) Where a firm uses the standardised approach set out in BIPRU 3 (Standardised approach to credit risk) for the calculation of risk weighted exposure amount for the standardised credit risk exposure class to which the securitised exposures would otherwise be assigned under BIPRU 3, then it must calculate the risk weighted exposure amount for a securitisation position in accordance with the standardised approach to securitisations set out in BIPRU 9.9, BIPRU 9.10, BIPRU 9.11